The SpeedWing Dart is a SUPER fast, SUPER agile and SUPER aerobatic 20” flying wing. Designed using space age carbon fiber, balsa and aircraft grade ply, this built-up kit is sure to surpass your wildest dreams for a super clean, fast and fun build for even more of a “Real Fun - Real Fast” experience in both building and flying. Using a minimal brushless motor/ESC setup, the SpeedWing Dart is fully capable of speeds in excess of 100 MPH! Maxed-out you can expect to see speeds reaching into the 150+ MPH range. Brushed or brushless motors in the Speed 400 size fit nicely in the triple reinforced aircraft grade 5 ply mount. In-runner and out-runner motors as well as CD-ROM motors can also be used. A large battery/receiver compartment, complete with a hinged magnetic latched & vented door, will accommodate up to 3s2p 1350 mAh Li-Poly battery packs, a micro receiver and ESC. The servo bay is fully enclosed as well except for 3 small servo control horn holes and is designed to fit micro servos such as the Futuba S3110 and Hitec HS-55. 

This all new SpeedWing utilizes a SUPER strong carbon fiber tube design with CF tape reinforced balsa spars and fully enclosed balsa and aircraft grade 3 & 5 ply center section. Designed to fly with or without rudder control, all necessary components and instructions are included for either build. All balsa and ply parts are fully CNC cut using “tab & slot” construction whenever possible to allow this wing to be quickly and easily framed up and ready for covering, usually in less then 2 hours. Utilizing these design methods also allows the SpeedWing Dart to be SUPER light as well as SUPER strong. When fully built and MonoCoat covered, the completed airframe weighs in at just 3 oz., with a full flying weight (AUW) from 9 to 16 oz.

This kit is easy to build and only requires about 3+ hours (depending on covering skills) to complete. Once finished, you will be rewarded with a SUPER stable, SUPER fun to fly wing. Although this kit isn’t recommended for beginners because of its SUPER high speed ability and SUPER agility, once you master the basics of flying R/C, you can handle this plane.

Included in this kit are all CNC cut balsa and ply parts pre-cut carbon tubes, carbon tape, CF hinge material, hatch cover magnets, pull-pull rudder hardware, CF control rod & clevis’, micro control horns, a complete instruction manual including pictures and full size layout/build plans.

Radio equipment needed:
micro receiver (GWS 4P or equivalent)
micro servos (Hitec HS-55 or Futaba S3110 )
Electronic Speed Control (ESC)
2~6 cell LiPoly battery pack(s)

Click to View Our Videos of this Wing!


Click to View Our Slide Show of this Wing!